Strand Lighting CD802412TR Dimmer CD80 24x1.2Kw

Strand Lighting CD802412TR Dimmer CD80 24x1.2 Kilowatt

Strand Lighting CD80 solid state portable dimmer packs have offered solid reliability to users for over 10 years with thousands of systems in use. This is a 2.4K watt maximum, 12 channel dimmer pack. This pack has 2- 20 Amp Twist-Lock Connectors per channel, so you can use more, lower wattage fixtures on each channel. The CD80 provides a rise time of not less than 350 microseconds. Output response time (from control signal change) is less than 0.1 seconds The pack regulates output voltage with changes in the AC line from 108 to 130 volts RMS. The optional Controller has dip switches to select the rack Mode, and one primary, fully magnetic circuit breaker for each dimmer, mounted to the front panel that provides protection for individual dimmers.

Features:

• Rugged dimmer packs for portable and permanent applications
• Full range of capacitates: 24 - 1.2kw, 12 -2.4kW, 24 - 2.4kW, 6 - 6kw, or 6 - 12kw
• All controls are recessed and flat front circuit breakers are used to prevent accidental damage to key components. All circuit breakers provide positive trip indication.
• Fully digital processor with simple to use front panel setup with alpha numeric display
• User selectable fade curves as well as minimum and maximum level selection
• Dual DMX inputs with mode selection. Daisy chain output passes combined levels on to next pack
• DMX input patching
• Local indicators for phase and over temp
• Plug-in processor
• Input and output XLR connectors for daisy chaining packs
• Entire pack is UL and CUL approved as an assembly and appropriately labelled
• Toroidal chokes for high-quality filtering
• Full range of output connectors: stage pin, twist locks, u ground and multi-pin socapex

Specifications

• Mechanical Data
  • Weight:
    • (2.4/6.0kW) 65lbs. (29kg), (12.0kW) 85lbs. (38.2kg)
    • Packed Volume: 5.7 cu ft
    • HxWxD: 8.5” (216mm) x 23” (597mm) x 20” (508mm)
  • Finish: Gray powder coat epoxy paint
  • Construction: Rigid folded sheet steel
• Environmental Data
  • Operating Temperature: 0°C to +35°C
  • Storage Temperature: 5°C to +55°C
  • Humidity Range: 10% to 95% non condensing
• Electrical Data
  • Supply Voltage/Frequency
    • 1.2kW, 2.4kW, 6kW: Three phase: 120/208V 50/60Hz
    • 12kW: Three phase: 120/208V 50/60Hz
  • Distribution
    • Three phase: 4-wire + ground
  • Pack Isolation
    • 2500V between low and high voltage sections of SSRs
  • Total Capacity
    • 2.4kW Max current (12/24 Dimmers): 3/0 4W 160A
    • 6.0kW Max. current: 3/0 4W 100A
    • 12.0kW Max. current: 3/0 4W 200A
  • Load Connections
    • Dimmer outputs are provided on the rear of the pack as follows:
    • 2.4KW: grounded pin or grounded twist lock(20A) with multi-pin Socapex connectors
    • 6kW: grounded pin 12kW: grounded pin (100A)
• Supply Connections
  • 12kW: Terminal strips or Cam-lok Circuit Protection
  • Each dimmer module is protected by a fully magnetic circuit breaker of 10kA fault current rating
• Operating Data
  • Control Input
    • Packs will support two DMX inputs with input patching and priority assignments. Local control at the processor permits on/off operation and level setting using the Set Level commands built into the processor.
    • DMX: 5-pin XLR, opt isolated from dimmer electronics
  • LED Indicators
    • Protocol in use, over temperature and phase
    • Control Cable Entry
  • Control Input
    • 5-pin XLR DMX
    • 2 - 5-pin DMX A and B
  • Local Control
    • Push buttons (full/normal) plus “panic” feature for instant on
  • Max Heat Dissipation
    • Approx. 3-5% of connected load (Convert watts to BTUs)
  • Cooling Method
    • 100CFM low noise fan
  • Dimmer Data
    • No of Dimmers: 12 or 24 x 2.4kW; 6 x 6.0kW; 6 x 12 kW
    • Dimmer Firing: Digital
    • Max/min Dimmer Loads: Min 12W Max 2.4, 6.0, and 12.0kW
    • Rise Time/Filtering: 350 microseconds
    • Over Temperature Protection: If SSR heatsink overheats, the O.T. indicator will turn on and the pack will shut down