Rode NT55MP Pair of Matched NT55 1/2-Inch Cardioid Condenser Microphone

Rode NT55MP Pair of Matched NT55 1/2-Inch Cardioid Condenser Microphone

The Rode NT55-MP Matched Pair Condenser Instrument Microphones utilize the 1/2-inch gold sputtered true condenser transducer used in the renowned Rode NT5. The NT55 Matched Pair have been acoustically matched to provide only the finest in recording quality and consistency. These low-noise, balanced output microphones exhibit a wide dynamic range and full frequency response. The Rode NT55 circuit incorporates a three position variable PAD with 0dB, -10dB or 20dB attenuation, and a three position variable high-pass filter that enables you to step from a flat response to 75 or 150 Hz high pass filter. The Rode NT55 mics come with two different condenser microphone heads to provide a wide variety of polar patterns. The NT55 is complemented with a diverse range of accessories to better facilitate positioning and attachment.

Features:

• Externally Biased Condenser
• Cardioid or Omni Polar Pattern Using Included Interchangable Capsules
• Gold Sputtered ½" Capsule
• Three Position PAD - 0dB, -10dB and -20dB
• Three Position High-Pass Filter - flat, 75Hz and 150Hz
• Surface Mount Circuitry
• Low Noise
• Available as a Single

Specifications:

• Acoustic Principle: Pressure Gradient
• Active Electronics: JFET impedance converter with bipolar output buffer
• Capsule: 0.50 inch
• Polar Pattern: Cardioid and Omnidirectional
• Address Type: End
• Frequency Range: 20Hz - 20kHz
• Output Impedance: 100ohms
• Maximum SPL: 136dB SPL (at 1kHz, 1 percent THD into 1K ohm load)
• Maximum Output Level: 8.0dBu (at 1kHz, 1 percent THD into 1K ohm load)
• Sensitivity: -38.0dB re 1 Volt/Pascal (12.60mV at 94 dB SPL) +/- 2 dB at 1kHz
• Equivalent Noise Level (A-weighted): 15dB-A
• Power Options: 48 phantom power
• Weight: 220.00gm
• Dimensions (HxWxD): 145 x 20 x 20mm