JBL PRX712 Speakers with EON618S Subwoofer
The PRX712 is the next step in the highly successful PRX Series and introduces the first use of JBL's patented Differential Drive Technology with ferrite drivers. Differential Drive technology incorporates lower mass in the ferrite magnet for reduced weight while maximizing power amp efficiency for greater heat dissipation and increased power handling. Powering the PRX712 is a 1500-Watt high performance, exceptionally low distortion biamplification system engineered to deliver clean power with maximum headroom to efficiently deliver smooth high frequencies and rich, deep bass response even at very high sound power levels. Compact, ultra-lightweight, the PRX712 uses JBLs tour tested technology throughout so you can trust it to deliver a lifetime of reliable performance.
The JBL EON618S is a powered portable PA subwoofer in the EON600 series from JBL Professional. It has been designed to deliver class leading performance in a variety of applications supporting EON600 and other full range systems. A lightweight, highly useful enclosure allows the speaker to be easily transported and set up wherever low frequency reinforcement is needed.
The On Stage Microphone Cable 20' XLR To XLR is the perfect microphone cable solution for the performer on a tight budget! Plug into your microphone, patch up to the mixer or the snake, and pump up the volume folks! XLR to XLR mic cable with rugged jacket is designed to handle a small backyard party or large scale event while preventing unwanted interference from entering the signal path. At this price you can outfit your whole rig with these value priced mic cables for clean, truly clear always noise-free music... rock on!
JBL PRX712 12-Inch 2-Way Full-Range Powered Speaker Features:- 135 dB peak SPL
- 12" Differential Drive low-frequency driver for low-distortion and higher SPL
- 1.5" diameter next generation JBL neodymium compression driver
- JBL designed waveguide for accurate coverage
- Efficient Class-D amplifier technology
- Optimized EQ for monitor or front-of-house applications
- DSP input section, crossover, dynamic limiting, component optimization, selectable system EQ
- Line level and direct microphone input capability
- Professional XLR+1/4" combination inputs, RCA inputs, and XLR loop-through
- Multi-angle enclosure for main PA or floor monitor applications
- Integrated 36mm pole mount socket with angle down tilt
- Injection molded handle with backing cup for easy transport
- Integrated M10 suspension points for easy setup
- Lightweight poplar plywood cabinets made structurally sound with tongue and groove joints and protected by JBLs tour proven DuraFlex finish.
- Cloth backed, dent-resistant 16 gauge steel grilles
- Power rating: 1500-Watts
- Frequency range (-10 dB): Main: 44.8 Hz - 19.6 kHz
- Monitor: 44.8 Hz - 19.5 kHz
- Frequency response (±3 dB): Main: 55.7 Hz - 18.2 kHz
- Monitor: 56.5 Hz - 17.7 kHz
- Coverage pattern: 90° x 50° nominal
- Directivity index: 10.2 dB
- Directivity factor: 10.4
- Crossover frequency: 1.8 kHz
- Maximum SPL: normal 135 dB, boost 135 dB
- Signal indicators: Limit - yellow LED indicates peak output has been reached and dsp limiter is acting. Signal - green LED indicates signal present. Power/standby - blue indicates system has power and ready to pass audio. Stand-by - red LED indicates system has power but is in a power saving mode and will not pass audio.
- Dynamic control (input): DBX Type IV limiter circuit
- Input impedance: 20K Ohms (balanced), 10K Ohms (unbalanced)
- Low frequency driver: 1 x JBL 272G 12" (305mm) woofer
- High frequency driver: 1 x JBL 2408H-2 1.5" (37.5mm) annular polymer diaphragm, neodymium compression driver
- Enclosure: asymmetrical, 18mm plywood
- Suspension / mounting: dual 36mm pole socket, 12 x M10 suspension points
- Transport: 1 x injection molded handles with backing cup
- Finish: obsidian duraflex finish
- Grille: powder coated, obsidian, 16 gauge perforated steel with acoustical transparent black cloth backing
- Input connectors: 2 x balanced XLR + 1/4", 2 x unbalanced RCA
- Output connectors: 1 male XLR balanced
- Dimensions: 24.11" x 15.14" x 13.44" (H x W x D)
- Net Weight: 42.5 lbs. (19.4 kg)
- JBL premium transducers
- 1000-Watt highly efficient Class-D amplification
- Frequency range (-10dB): 31Hz - 150Hz
- Frequency response (- 3dB): 42.5Hz - 150Hz
- Bluetooth control: 3 parametric EQs + high & low shelf, gain and delay, save and recall settings, polarity inversion
- JBL engineered crossover presets: 80Hz, 100Hz, 120Hz & EON
- M20 pole cup
- Rugged, stage-ready Duraflex enclosure
- System type: self-powered 18" subwoofer
- Maximum SPL output:134 dB
- Frequency range: (-10 dB) 31Hz 150Hz
- Frequency response: (-3 dB) 42.5Hz - 150Hz
- System power rating: 1000W peak, 500W continuous
- Input impedance: 22k (balanced)
- Line input: gain 0 to 36 dBu
- Line: +14dBu
- Connectors:2 x balanced XLR+1/4" combination inputs; 2 x male XLR loop thru out
- Cooling: passive
- AC power input:100-120VAC 50/60Hz; 230-240VAC 50/60Hz
- AC power consumption: (120V~) 1/8th power - 1.14A (max.), 1/4th power - 1.71A (max.), 1/3rd power - 2.03A (max.)
- Low frequency driver: 1 x JBL 618H 18" (457mm) woofer with 2" voice coil
- Crossover Frequency: selectable - 80 Hz, 100 hz, or 120 Hz
- Material: Duraflex coated wooden enclosure
- Suspension & mounting: M20 threaded pole cup
- Handles: 2
- Grille:Powder coated, Obsidian, perforated steel with acoustically transparent black cloth backing
- Dimensions: 22.9" x 26.3" x 25.4" / 582mm x 668mm x 645mm (L x W x H)
- Weight:72 lbs. (35.5 kg)