D&B Audiotechnik Z2880.000 5D Amplifier

The 5D is a Class D installation amplifier with flexible power distribution among its four output channels. It uses Digital Signal Processing (DSP) to incorporate loudspeaker-specific configurations for smaller loudspeakers from E-Series, xS-Series, xC- and T-Series, as well as equalization and delay functions. A linear setup is available allowing the amplifier to be used as a linear installation power amplifier. The amplifier has a dynamic range of 111 dB (Dante input, unweighted) and is designed to drive a selected range of d&b loudspeakers while providing comprehensive management and protection capabilities.

Specifications:

• Digital Signal Processing:
  • Latency analog and digital inputs: 1.1 ms / < 3 ms
  • Configurations: Selected loudspeakers from E-Series, xS-Series, xC Series, T-Series; Linear setup
  • Frequency generator: Pink noise or Sine wave 10 Hz – 20 kHz
• Controls and indicators:
  • Display: LED indicators
• Connectors:
  • Ethernet, Dante Input: 2 x RJ 45, 1 Gbit / 100 Mbit GPI: 1 x 6-pin Euroblock 3.5 mm male Input / Link ANALOG (A1-A4): 2 x 6-pin Euroblock male, 3.5 mm Speaker outputs A/B/C/D: 2 x 4-pin Euroblock 5.08 mm female Mains connector: IEC FAULT: 1 x 3-pin Euroblock 3.5 mm male
• Power supply:
  • Type: Wide range switched mode power supply with active Power Factor Correction (PFC)
  • Rated mains voltage: 100 - 240 V, 50 - 60 Hz
• Dimensions / weight:
  • Dimensions (H x W x D): 1 RU x 9.5" x 435 mm/17.1"
  • Weight:
    • 4.6 kg
    • 10 lb